Wallpaper Roll
MaterialWalls
Cost & Purchase Summary
QuotationWall Strip Plan
Seam layoutRoll Cutting Plan
Best-fit layoutDetailed Strip Cutting Schedule
Actual Consumption & Job Closing
Planned vs actualCut order Strip Wall Strip width Planned cut Actual cut (mm) Match / offset Piece type Hang Roll / Source Remaining after cut Reuse Result Site note Cut Installed
Select an enabled WooCommerce wallpaper product to load its roll and pattern specification.
Manual / Library modeNo WooCommerce product selected.
Select a saved company/design. Roll size and design match load automatically.
Wallpaper specificationSelect a wallpaper above to see its roll size and design-match details.
Base design repeat / rapport.
±%
This is the manufacturer roll-size tolerance printed like 10m ±5% or 9.5m ±3%. It is not the design repeat.—
For roll quantity, the optimizer uses the minimum possible roll length so material does not run short.Leave 0 to use safe manufacturer tolerance. Enter the measured length only when you know the exact roll length.
No repeat / free match
Half-drop automatically uses half of the repeat as the B-strip offset.Extra phase/offset applied according to sequence.
Alternate applies the offset to B strips only.
Remaining roll length at or above this value is saved as reusable stock; smaller pieces count as scrap.
Auto mode optimizes only strips fully inside a door/window when the wallpaper has no repeat. Patterned wallpapers keep full drops for guaranteed design continuity.
Trim allowance at door/window cut edges.
Wall 1Feature wall
ft + inch mode: 12.6 = 12'6"
ft + inch mode: 9.4 = 9'4"
Motif mode centers the selected motif point on the wall.
Preferred minimum distance between a seam and obstacle edge.
Controls installer sequence and strip numbering.
Use only when the wallpaper manufacturer specifies reverse hanging.
%
0% = left edge, 50% = center, 100% = right edge of the design repeat across the roll.Required rolls—Select wallpaper and enter wall size
Total strips—
Material used—
Reusable leftover—
Scrap waste—
Roll specification—
Design match—
Door / window impact—
Total strips—
Total rolls used—
Stock rolls used—
New rolls needed—
Material used—
Reusable leftover—
Scrap waste—
Utilization—
Opening saved—
Doors / windows—
Rolls saved by openings—
Wall area—
Material cost—
Installation—
Other charges—
Discount—
Tax / GST—
Estimated total—
Suggested advance—
Balance—
Select an enabled WooCommerce simple product.
Roll assignment, reuse & site execution
Cut progress0 / 0
Installed progress0 / 0
Planned cuts—
Actual cuts—
Variance—
Damaged0
Re-cuts0
Extra rolls0
Final leftover0 mm
Actual scrap0 mm
